recommended mod route? - Page 3 - 4th F-Body

99Hugger · August 14th, 2010, 02:27 PM

I used a Baker Hose, no hump and still felxible.

safemode · August 14th, 2010, 04:43 PM

Yea, but from the looks of the back of your lid, that hose is putting some serious pressure on trying to straighten back out (it's also pushing it forward quite a bit too). It does look smoother though. If the bend could be heat treated into the hose so that it no longer wanted to straighten out, i think that solution would be the best of both worlds.

99Hugger · August 14th, 2010, 06:33 PM

There is no way it's going to straiten out.... What you're not noticing is that I'll always have a greater bend on the hose due to the raised WS6 lower box. I prefer the baker hose. No proof but i'm sure the air is less turbulent without the bulging center. All minor shit though...

Cant wait for your next write up on your K&N install!!

safemode · August 14th, 2010, 08:08 PM

not going K&N. No point as it doesn't flow better unless the paper filter is clogged.

I'm doing speakers next. Replacing all of them, adding another amp and cap. I'll do a little writeup on how fun that is. Exhaust will probably be the end of the month. Still deciding what to go with. Next month is SFC's.